Set of Dexterity Puzzles

These are a set of limited edition Dexterity Puzzles of of a total 100. Each puzzle is numbered and signed. 

Each puzzle has been handmade using a manual mill and manual lathe. There will be machine marks. Each puzzle has an acrylic lid to stop the balls coming out

Descriptions of each below:

De-ruption – Using a bit of imagination I’m hoping you can see that it looks like a bit of a volcano. There are 4 rocks (balls) that you need to get back inside the volcano to clean up the mess. I’d like to say I’ve made it slightly easier by making some ridges on each level to help them climb back in. There are no cunning tricks; balls are high quality stainless steel. You just need a bit of time, patience and luck

On a Level – In some ways, I’ve already given you a head start on this one. As the largest ball will remain in the top position. All you need to do is put the remaining ball bearings on each designated spot to end up with a nice and tidy shelf. The only trouble is, you will need to guide the smaller ball bearings around each of the larger holes and make sure they don’t fall back through. As I found out myself, a small knock can make you start all over again even once you have achieved your goal. As such, I’ve made a stand for them to sit on once the task is completed.

Corner to Corner – Now all of my puzzles can’t be round now can they! You will find 4 ball bearings and 4 rings. The ball bearings need to sit on their individual spot and the rings need to sit as a group in theirs of which is slightly milled down. Be careful of the traps

Each puzzle is 1 1/2 inch in diameter made from brass.